pop out short message
could you tell me which pid i should use to make pop out short message?
Posted by alex qian, email@example.com
RE: pop out short message
Posted by Forum Nokia Developer Support,
on March 12, 2002 at 14:47
If you are referring to a "flash" message, i.e. one which is displayed on the phone screen briefly upon reception, the PID is not the important bit.
You need to use the DCS byte (Data Coding Scheme) to set the class of the message to 0.
The coding of the DCS byte depends on the type of message you are sending. See 3GPP TS 23.038 for more details.
Forum Nokia Developer Support