JSR-179 System Architecture
Am I right?
If the customer want to use JSR-179 enabled mobile device and AP, the operator(carrier) need to setup their own equipment and send location data within the signal.
So even I have a JSR-179 enabled mobile device and suitable AP, I still may not be able to run the AP correctly.
So if we want to write JSR-179 AP, there are two things I need to confirm. Withour these three requirements, it will be impossible to use JSR-179 enabled AP.
1. Mobile phone support JSR-179
2. Operator must have relative tech. and quipment.
I am not sure this assumption is correct or not. Does any one can point out where is the problem or this is just right.
Thanks a lot