Hello to everyone,
I've setup my Debian laptop and my Nokia 6630 so that the phone can connect to the Internet by using the laptop ADSL connection via Bluetooth.
All the above is achived with Gnubox.
I can ping the phone from the PC and viceversa.
I can surf the web with Opera on the phone using the phone "Bt" (the name of the "Access Point" created with Gnubox).
Next, I wanted to try Raccoon (actually all of the above have been setup to try Raccoon...) and the results are:
- I can see the webserver on the phone from my PC by opening Firefox and inserting the URL "10.0.0.2", which is the IP of the phone.
- I can successfully test all the demo apps and btw they are all very inspiring.
- I can connect to the phone webserver directly from the phone with Opera.
What I can't do is access raccoon on the phone by passing trough the Nokia gateway. I've tested from both the local PC and a remote host.
When I start Raccoon on the phone with "Start w. Connector" only the Webserver is started, the Connector stays "Not Connected".
The same if then I try to "Start Connector", and again if in the "Connector" tab I try to "Go online".
Is there something I am missing?
On the wiki the installation istruction say that after starting w. connector I'm supposed to "choose an access point that you use for browsing the Internet": If there is supposed to popup some prompt for this parameter I just don't get it, there is no place in Raccoon where I can set the AP.
Just as I natted via Iptables on the Linux box the outcoming connections to 10.0.0.2 am I supposed to set up the firewall to allow incoming connections to 10.0.0.2 from Nokia gateway IP address?
Some details of my setup:
Firmware V 6.03.08 13-02-06 RM-1
Thanks in advance,