×

Discussion Board

Results 1 to 4 of 4
  1. #1
    Registered User
    Join Date
    Mar 2003
    Posts
    1

    D211 skript problem on SuSe Linux

    Hi,

    I have compiled the source code of "nokia_d211-linux-1.04.tar.gz" on a IBM Thinkpad 600E with SuSe linux 8.1 on Kernel 2.4.19. After some manual adaptations, the WLAN part of the card works fine including WEP security.

    The problem: In the NOKIA_CS skript the command
    (initlog -c "$NOKIA_CS" &amp is used, which is not supported by SuSe linux. That means that the daemon is not started when the card is inserted. When I change the command to "$NOKIA_CS &" the daemon is startet, but not stopped anymore, probably because the output of the command is not logged by initlog -c.

    Is there any solution/workaround for this problem?

  2. #2
    Registered User
    Join Date
    Mar 2003
    Posts
    5

    RE: D211 skript problem on SuSe Linux

    D211 works and is only supported with Red Hat Linux.
    change from Suse to red Hat.

  3. #3
    Registered User
    Join Date
    Mar 2003
    Posts
    1

    RE: D211 skript problem on SuSe Linux

    I changed the command to "$NOKIA_CS" & and it works.
    The & must be outside of the quotes.

  4. #4
    Registered User
    Join Date
    Jul 2003
    Posts
    4

    Auto-stopping of daemon

    After editing the line 49 to

    "$NOKIA_CS" >/dev/nul 2>&1

    the daemon will stop by itself.

    This changes are necessary under Debian and SuSE-Linux

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
×