×

Discussion Board

Results 1 to 2 of 2

Hybrid View

  1. #1
    Super Contributor
    Join Date
    Mar 2003
    Posts
    1,733

    Remote signal strength

    Posted by Colm Breathnach, colmbreathnach@intactasoft.com
    on February 25, 2002 at 11:09

    If you are placing a data call to a remote terminal, n20 or n30, is there a way to read the signal strength at the remote terminal?
    I can read the signal strength at the near end ok, (AT+CSQ), but can I get the remote to send me the signal strength at the distant end? I don't want to change the remote programming, so I need to do it all at the near end. Any ideas?

  2. #2
    Super Contributor
    Join Date
    Mar 2003
    Posts
    1,733

    RE: Remote signal strength

    Posted by Forum Nokia Developer Support,
    on February 28, 2002 at 18:09

    You can get the signal strength from the terminal in the M2M system mode by programming this logic to the server side application. Remote AT command will not work.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
×