Posted by Richard Stok, richard@stok.co.uk
on May 05, 2002 at 13:52



Hello,

I am having difficulty with getting my NCP2 to work with data calls. I have insatlled and configured the drivers and it works fine as an SMS terminal, it also reports the 43.2 up/19.2 down connection speeds after setting them.

I have turned off the card phone monitor, I run dial up networking, having checked NCP2 is selected as modem, but keep getting "Cannot connect. Make sure you don't have an IR send or receive active and try again. If the problem persists, turn the device off, and then try again."

I am not knowingly using IR port, but don't know how to turn it off. can any one help get me up and running with NCP2 dial up please?

Richard Stok (UK)