has anyone got the debug monitor on a 3650 to work

look in the sdk under:
» Developer Library » Base Porting Guide and Reference » Porting the base » Debug monitor » Using the debug monitor

this is what you must do:

Using the debug monitor


Starting the debug monitor
If the Kernel or a system process panics, or if there is an unhandled processor exception, the Kernel beeps 4 times and enters the debug monitor.

To use the debug monitor:

Plug the mains adaptor into the DC jack.

Connect the machine serial port to your PC and set the PC serial port to 115200 baud, 8 bits, no parity, 1 stop bit, XON/XOFF flow control.

Press the ON key on the machine.

Start a terminal program on the PC (e.g. HyperTerminal.)

Press RETURN on the PC. The machine should reply

Enter the password "replacement" (all lower case, without the quotes). The machine should now reply

You are now ready to use the debug monitor.

looks simple, but doesn't work for me