Hello,

I'm trying to figure out how I can control the display of the Access Point dialog (the dialog that says "Choose Access Point") when I start an outgoing network connection.

On Series 60 1.x devices, I was able to use something like:

CCommsDatabase* pCommDB = CCommsDatabase::NewL(EDatabaseTypeIAP);
CleanupStack::PushL(pCommDB);

pCommDB->SetGlobalSettingL("AskUserBeforeDial", ETrue);

However, I find that on Series 60 2.x devices, I get a leave error: "Not supported"

What's the proper way to change this Access Point dialog preference on Series 60 1.x and 2.x ?

thanks for your help!