×

Discussion Board

Results 1 to 2 of 2
  1. #1
    Registered User
    Join Date
    Sep 2004
    Posts
    9

    How to access internet in the emulator of Series 60?

    I try to config the emulator by setupcomms.
    i have followed the below instruction to configure my emulator:

    run setupcomms and choose item a) Modems:

    Set PortName to COMM::<port-number>, e.g. COMM::0 for COM1.

    Set TSYName to MM

    Set CSYName to ECUART

    But when i try to use the dial-up service in the emulator, the emulator just keep on trying to establish the dial up connection.....

    My computer have no com port!!
    Last edited by ccwhk; 2004-11-04 at 14:55.

  2. #2
    Super Contributor
    Join Date
    May 2003
    Location
    Vancouver, Canada
    Posts
    985
    Then you need to create a virtual COM port. There is a software from www.eltima.com that is able to create ones in your PC. The license is a little bit expensive (unfortunately).

    Antony

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
×