Hi i was trying to connect my emulator to the internet and i found a way to do it. (by reading lots of forums and documents)
Here is the way to do it.............................
1. Install Microsoft LoopBack Adapter.( Select from list in installing new device [network adapters ]) Lets Call It !! MLBA !!
(add new hardware will be used to do that....... new network adapter will be choosen)
2. Go to the properties of Inet connection on the last page make it shared for LAN of MLBA (firewalled or not doesnt matter)
After You do this Windows will automaticly assign ip address for MLBA and will ask you to not change it. (maybe windows will not ask anything)
3-Run cmd ipconfig and see what ip and subnet mask has MLBA remember it!
for example lets assume it will be:
ip : 192.168.0.1
subnet mask: 255.255.255.0
4. Goto the ""Start > Programs > Series 60 Developer Tools > SDK 2.1 for Symbian OS Supporting Microsoft Visual C++ .NET> Tools > Ethernet Support Configuration""
Check network adapter in promisicuous mode
select use the following ip address
in the field ip type: 192.168.0.2
in the field mask: 255.255.255.0
in the field Gateway!!!! : 192.168.0.1
!!!!(The trick is to use in Gateway ip of your MLBA ) !!!!
type any DNS but it must be working DNS.
proxy is not needed.
And after all, select button "Adapters" and choose your MLBA.
(it will ask the adapter which you will use in the command prompt)
So after all this manipulations all must be working.
Use services or the famous httpexample to test your emulator.....
if any question i will try to answer .....