I am having some problems with debugging imlets on an aplicom 12 module. I am trying to use serial port 3 to send debug information from the module to a pc.

The imlets seem to be running ok on the module, however when i want to get the debug information back, it doesnt seem to be happening.

In the aplicom 12 configurator in module configuration, I have set port 3 to be the java serial port, the code I am using to open the serial port is

sc=(StreamConnection) Connector.open("comm;3:buadrate=115200", Connector.READ_WRITE);

I am then trying to connect to Hyper terminal on the PC.
I have set Bit per second to: 115200
Data bits: 8
parity: none
stop bits: 1
flow control: none

Hyper terminal doesnt display any information with these settings.

Any help or advice you can give me would be greatly appreciated.

Many thanks